Refrigerators and freezers
When a refrigerator runs without cooling, the condenser coils are usually the first stop. In apartments, those coils hide underneath or behind the toe grille, matted with dust and pet hair that force the compressor to overwork. Then the tech listens for the evaporator fan behind the freezer wall, since a failed fan keeps the freezer cold while the fridge side warms up. Heavy frost on the evaporator coil points to the defrost system, so the heater, defrost thermostat and control board each get a continuity check with a multimeter. Repeated clicking with no compressor hum often means the start relay or overload has failed.
Washers
Standing water in a washer usually traces back to the drain path. The tech checks the pump filter for socks, coins and hair ties, then tests the drain pump motor itself. If the machine will not start or spin, the lid switch on a top-loader or the door lock assembly on a front-loader is a common culprit. Loud banging during spin points to the suspension: worn shock absorbers, springs or a cracked spider arm on the drum.
Dryers
An electric dryer with no heat usually has a blown thermal fuse or dead heating element, while a gas dryer with no heat often has a weak igniter or bad valve coils. A drum that sits still suggests a broken belt, while squealing or thumping points to worn drum rollers or the idler pulley. Here is the part people skip: a thermal fuse blows for a reason, and that reason is usually a clogged vent. In high-rise buildings with long vent runs, a good tech checks airflow at the exhaust before closing out the job.
Dishwashers
Water pooling in the tub starts with a check of the filter and drain hose, then the drain pump. If the unit hums but never fills, the tech tests the water inlet valve and its solenoid. Dishes coming out wet and cold suggest a failed heating element or high-limit thermostat.
Ranges, ovens and cooktops
When a gas oven clicks without lighting, the hot surface igniter has usually weakened and no longer draws enough current to open the safety valve. The tech checks that with a clamp meter, and may use a manometer to confirm gas pressure at the regulator. Electric ovens that heat unevenly often have a broken bake or broil element, and ovens that run hot or cold usually have a drifting temperature sensor, checked against the resistance chart on the tech sheet.
Microwaves
If the light and turntable work but food stays cold, the magnetron, high-voltage diode or capacitor may be at fault. A microwave that is completely dead often has a blown fuse caused by a failed door switch. Do not open a microwave on your own, because the high-voltage capacitor can hold a lethal charge long after unplugging, and a trained tech discharges it safely before any work begins.